Pn16 One Way Rubber Disc Flange Cast Iron Check Valve for Oil Pipeline Valves

Product Description

Check valve is basically a one-way valve, in which the flow can run freely one way, but if the flow turns, the valve will close to protect the piping, other valves, pumps etc. If the flow turns and no check valve is installed, water hammer can occur.

A check valve, also called a one-way valve, is a device that allows the flow of fluids to move only in one direction. The primary purpose of a check valve is to prevent backflow in the system. Check valves are cheap, effective, and easy solutions to a potential issue. Backflow can cause a problem if the flow is contaminated and, therefore, contaminates the media upstream. For example, a sewer line will have a non-return valve to ensure that waste can leave but not re-enter the system it came from. Figure 1 shows an example of a check valve.

There are various sizes, designs, and materials to ensure there is a check valve for every application. Two-way check valves are commonly used. Check valves with vents are used as three-way check valves to protect the incoming water supply from contamination caused by backflow. The atmospheric vent allows the disposal of purged water into an existing drain. An arrow on its bonnet indicates the check valve flow direction.




Backflow should be avoided.
Capable of withstanding both high and low pressures.
Ability can be utilized horizontally and vertically as a backup and safety system.
Self-actuated.
Quick to react.
Backflow protection is necessary to avoid damage to pumps and compressors.
Reduce downtime and production losses.
Water hammer can be avoided.
Reduce the likelihood of unexpected valve failure.
Maintenance expenditures are reduced.
There are only a few moving pieces.
A smaller carbon footprint.
Adaptable to varying flow conditions.
Does not need the use of electricity to function.



Check valves are very flow-sensitive, which means they open and close based on the flow of the line fluid. The interior disc enables which helps to flow forward, allowing the valve to open. Based on the design, the disc starts shutting the valve when forward flow diminishes or reverses.

Check valves are very flow-sensitive, which means they open and close based on the flow of the line fluid. The interior disc enables which helps to flow forward, allowing the valve to open. Based on the design, the disc starts shutting the valve when forward flow diminishes or reverses. The body, seat, disc, and cover are usually the only parts that need to be assembled. Other components may include a stem, hinge pin, disc arm, spring, ball, elastomer, and bearings, depending on the design.






In pipes and similar devices and equipment, check valves are generally used to prevent a reverse flow by allowing materials or fluids to flow in only one direction. Despite their various forms, sizes, and functions, these valves generally operate based on the same principle. 

The primary components of a check valve include the Body,Body Seats,Gasket,Cover Plate,Hinge,Nuts,Washer.

 

 

 

NPS	2	2 1/2	3	4	5	6	8	10	12
DN	50	65	80	100	125	150	200	250	300
L	213	250	254	368	407	457	546	648	762
H(Open)	251	265	282	320	363	380	579	663	771
Kv	59.5	81.9	102.4	1690	341.9	409.4	797	1150	1774
Cv	69.4	95.6	119.5	197.2	399.0	477.8	930.1	1342.1	2070.3